ARN-30 \(see 6.1 and 6.3\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-PRF-55359A(CR)

DRAWINGS

COMMUNICATIONS-ELECTRONICS COMMAND

DL-SM-A-498900

Antenna Assembly AS-1304( )/ARN-30

(Copies of these drawings are available from Commander, U.S. Army Communications-

Electronics Command, ATTN: AMSEL-LC-LEO-E-EP, Fort Monmouth, NJ 07703)

2.3 Non-Government publications. The following document forms a part of this document to the

extent specified herein. Unless otherwise specified, the issues of the documents which are DoD adopted are

those listed in the issue of the DoDISS cited in the solicitation. Unless otherwise specified, the issues of

documents not listed in the DoDISS are the issues of the documents cited in the solicitation.

AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)

AMERICAN SOCIETY for QUALITY CONTROL (ASQC)

ANSI/ASQC Z1.4

Sampling Procedures and Tables for

Inspection by Attributes (DoD adopted)

2.4 Order of precedence. In the event of a conflict between the text of this document and

the references cited herein, the text of this document takes precedence. Nothing in this document,

however, supersedes applicable laws and regulations unless a specific exemption has been

obtained.

3. REQUIREMENTS

3.1 First article samples. The contractor shall furnish three preproduction samples for

approval (see 4.2 and 6.2).

3.2 Construction. Design and construction of the antenna shall be the contractor's

responsibility. However, the interface and dimensional requirements of DL-SM-A-498900 shall

be met.

3.3 Cleaning.

3.3.1 Parts. After fabrication, parts shall be cleaned. Cleaning processes shall have no

deleterious effect. Corrosive material shall be removed completely before the parts are mounted

on chassis, panels, etc.

3.3.2 Units. After assembly, units shall be cleaned thoroughly and shall be free from

particles of solder, flux, and other foreign material. In addition, when necessary, such cleaning

shall also be performed before final assembly of the units.